TIXstream MFT - Known Issues

The information in this document is property of TIXEL GmbH. It may not be used, reproduced or disclosed without written approval of TIXEL GmbH.

Notice of non-liability:

TIXEL GmbH is providing the information in this document to you AS-IS with all faults. TIXEL GmbH makes no warranties of any kind (whether express, implied or statutory) with respect to the information contained herein. TIXEL GmbH assumes no liability for damages (whether direct or indirect), caused by errors or omissions, or resulting from the use of this document or the information contained in this document or resulting from the application or use of the product or service described herein. TIXEL GmbH reserves the right to make changes to any information herein without further notice.

This document lists known issues for the below mentioned software version of TIXstream MFT software components. Entries may have an ID at the end of the line for internal reference.

Software Version - Document Version: v1.8.0-1.4

Known Issues

Version 1.8.0

Package

perf-stats-path parameter for logging performance data in TXS should only be used for testing and debugging, since it might consume significant amount of memory depending on the size of the transfer job.
TIXstream fails to start transfer when sender and receiver profiles use different timer settings. Please make sure to configure the Timer parameter in section [Receiver/Stream/RwtpNetworkReceiver] of FileTransferReceiver.config and [Sender/Stream/RwtpNetworkSender] of FileTransferSender.config symmetrically on one host. I.e. set it either to TSC or BoostChrono. However, usually those parameters don’t have to be modified (#7934).